Lucent Technologies Network Access Module ユーザーズマニュアル
B-1
Cable Specifications
B
This appendix provides cable and pinout specifications.
Cables Specified
•
Console Cable. This null modem cable is used to connect a terminal or PC to the
console port of the INA module.
console port of the INA module.
•
T1/PRI Cable. This cable is used to connect a T1/PRI line to the INA module.
•
Ethernet Interface Cable. This cable is used to connect the Ethernet connector on
the INA module to an Ethernet hub.
the INA module to an Ethernet hub.
•
Crossover Cable. This cable is used to make a simulated network connection
between the INA module’s Ethernet port and a free-standing computer workstation.
between the INA module’s Ethernet port and a free-standing computer workstation.
Console Cable
Table B-1 shows the cable pinouts for a RJ-45-to-DB-25 null modem cable. The INA
module does not use Data Set Ready (DSR).
module does not use Data Set Ready (DSR).
Table B-1
Console Cable Pinout
INA Module
Serial Port (C0)
Serial Port (C0)
PC or terminal
Serial Port
Serial Port
RJ-45
Name
Definition
Direction
DB-25
(DTE)
(DTE)
Signal
1
RTS
Request to Send
Output
5
CTS
2
DTR
Data Terminal Ready
Output
8
1
1. Pins 8 and 6 in the DB-25 connectors are connected internally.
DCD
3
TXD
Transmit Data
Output
3
RXD
4
GND
Signal Ground
NC
2
2. Not connected.
5
GND
Signal Ground
7
GND
6
RXD
Receive Data
Input
2
TXD
7
DCD
Data Carrier Detect
Input
20
DTR
8
CTS
Clear to Send
Input
4
RTS
NC
2
Data Set Ready
6
1
DSR