Enfora GSM2218 ユーザーズマニュアル
Regulatory Compliance
FCC
The modem was tested and certified to meet FCC Parts 15 in a stand-alone configuration, which
demonstrated that the GSM2218 MT-GL complies with Part 15 emission limits. FCC Part 22 & Part
24 is covered by the Enfora Enabler-IIG "modular approval" process for a transmitter. This
approach, described by FCC Public Notice DA 00-131407 released June 26, 2000, is intended to
afford relief to equipment manufacturers by eliminating the requirement for obtaining a new
equipment authorization for the same transmitter when installed in a new device.
FCC
The modem was tested and certified to meet FCC Parts 15 in a stand-alone configuration, which
demonstrated that the GSM2218 MT-GL complies with Part 15 emission limits. FCC Part 22 & Part
24 is covered by the Enfora Enabler-IIG "modular approval" process for a transmitter. This
approach, described by FCC Public Notice DA 00-131407 released June 26, 2000, is intended to
afford relief to equipment manufacturers by eliminating the requirement for obtaining a new
equipment authorization for the same transmitter when installed in a new device.
In order to use the GSM2218 MT-GL without additional FCC certification approvals, the installation
must meet the following conditions:
For the transmitter to meet the MPE categorical exclusion requirements of 2.1091, the
ERP must be less than 1.5 watts for personnel separation distance of at least 20 cm (7.9
in). Therefore, the maximum antenna gain cannot exceed +3.3dBi. If greater than 1.5
watts exists, then additional testing and FCC approval is required.
ERP must be less than 1.5 watts for personnel separation distance of at least 20 cm (7.9
in). Therefore, the maximum antenna gain cannot exceed +3.3dBi. If greater than 1.5
watts exists, then additional testing and FCC approval is required.
R&TTE -
The GSM2218 MT-GL modem has been fully tested and complies with all the requirements of EN301
489-1, EN301 489-7 and EN60950-1:2001. Compliance to EN301 511 has been demonstrated by
testing on both the GSM2218 and the integrated GSM0108 module.
489-1, EN301 489-7 and EN60950-1:2001. Compliance to EN301 511 has been demonstrated by
testing on both the GSM2218 and the integrated GSM0108 module.
Disclaimer
The information and instructions contained within this publication comply with all FCC, GCF, PTCRB,
R&TTE, IMEI and other applicable codes that are in effect at the time of publication. Enfora disclaims
all responsibility for any act or omissions, or for breach of law, code or regulation, including local or
state codes, performed by a third party.
Enfora strongly recommends that all installations, hookups, transmissions, etc., be performed by
persons who are experienced in the fields of radio frequency technologies. Enfora acknowledges that
the installation, setup and transmission guidelines contained within this publication are guidelines,
and that each installation may have variables outside of the guidelines contained herein. Said
variables must be taken into consideration when installing or using the product, and Enfora shall not
be responsible for installations or transmissions that fall outside of the parameters set forth in this
publication.
Enfora shall not be liable for consequential or incidental damages, injury to any person or property,
anticipated or lost profits, loss of time, or other losses incurred by Customer or any third party in
connection with the installation of the Products or Customer's failure to comply with the information
and instructions contained herein.