Western Digital Network hard drive ユーザーズマニュアル

CONNECTING THE NETCENTER – 8

NETCENTER

USER MANUAL

The reset button is recessed and requires the use of a fine-tipped stylus or the tip of a paper 
clip to press. Two types of reset modes are available: long reset or short reset.

Press the reset button momentarily (no more than one second). The NetCenter shuts down. 
Wait five seconds and press the power button. All settings remain intact.

Note: Long reset should be used under special circumstances only.

Press the reset button and hold down for 10 seconds. After 40 seconds, the NetCenter will 
reboot.

Note: The NetCenter will need to be set up again after a long reset. Long reset sets the 
network settings to DHCP client, clears the password, and resets the device name to 
“WD-NetCenter.”

1. Plug in and power on the USB printer.
2. Connect one end of the USB cable to the printer.
3. Connect the other end of the USB cable to an available USB port on the NetCenter. After 

initial setup is complete, the NetCenter will recognize the printer (see “Printer Sharing” 
on page 37).