WatchGuard Technologies V60 ユーザーズマニュアル
CHAPTER 1: Hardware Descriptions
8
Vclass
appliance if the power goes out, prompting the
appliance to shut itself down properly.
appliance to shut itself down properly.
UPS devices from American Power Company
(APC) are currently supported by the Firebox
Vclass power management firmware. Check the
WatchGuard Web site (www.watchguard.com) for
updated information on complete UPS support.
(APC) are currently supported by the Firebox
Vclass power management firmware. Check the
WatchGuard Web site (www.watchguard.com) for
updated information on complete UPS support.
N
OTE
In the event of a power failure, this security appliance, if left
connected to the power source, will automatically restart
itself after electrical power has been restored. You do not
have to press either the Power button on the front or the
power supply switch on the back of the appliance.
connected to the power source, will automatically restart
itself after electrical power has been restored. You do not
have to press either the Power button on the front or the
power supply switch on the back of the appliance.
The Firebox V100 model
The front panel of the Firebox V100 security appliance con-
tains the features shown in the following illustration.
tains the features shown in the following illustration.
Gigabit interfaces
Two Gigabit Ethernet interfaces, labeled 0 and 1
(corresponding to Private and Public), act as the
primary conduits through which network traffic
(corresponding to Private and Public), act as the
primary conduits through which network traffic
HA
100 10
HA2
100 10
HA1
Console
Ready
Admin
Alarm
Reset
Power
High Availability
(HA Interface)
(HA Interface)
Ready
Admin
Alarm
Power LED
Reset port
High Availability
Status LED
Console Interface
Rx
Tx
Link
Rx
Tx
Link
Rx
Tx
Link
Tx
Link
Rx
Tx
Link
Tx
Link
0 (Private)
1 (Public)