Zhone Technologies Z-PLEX-10-24-DOC-SC ユーザーズマニュアル
Zhone Technologies / 4-11
Configuring the Z-Plex
Adding and deleting routes
3. Specify the T1 interface the data is coming in on:
user>
SET DPCFG:WAN:1:2
4. Specify the number of channels:
user>
SET DPCFG:NCHAN:1:24
5. Specify the start channel:
user>
SET DPCFG:SCHAN:1:1
6. The remaining commands specify the operation control leads of the V.35 port. By default,
all the port leads are off. If your configuration requires you to change them, use the
following commands:
following commands:
user>
SET DPCFG:TM:1:(ON/OFF)
user>
SET DPCFG:DSR:1:ON
user>
SET DPCFG:RLSD:1:(ON/OFF)
user>
SET DPCFG:CTS:1:(ON/OFF)
user>
SET DPCFG:CTSDELAY:1:(0-100)
7. If you’ve made changes to the WAN, SCHAN, or NCHAN parameters, the system
automatically sets the port to STDBY mode. You must then re-activate it as follows:
user>
SET DPCFG:STATE:1:ACTV
4.9
Adding and deleting routes
You can create up to 16 static host routes and 16 static network routes. Static routes in the
Z-Plex enable it to reach management stations.
Z-Plex enable it to reach management stations.
4.9.1
Adding and deleting network routes
To add a network route, enter the following command:
user> SET ROUTE:ADDNETRT:x:destination:gateway
Where x is the number of the route, destination is the destination address, and gateway is the
gateway address. For example, the following command creates a network route (route
number 1) to the 192.168.0.0 network using the gateway 128.23.21.1:
gateway address. For example, the following command creates a network route (route
number 1) to the 192.168.0.0 network using the gateway 128.23.21.1:
user> SET ROUTE:ADDNETRT:1:192.168.0.0:128.23.21.1
To delete a network route, enter the following command: