Zhone Technologies Z-PLEX-10-24-DOC-SC ユーザーズマニュアル
5-8 \
Zhone Technologies
Model No.
Running Head
Testing FXO and FXS ports
Diagnostics
user>
SET FXSCFG:LOOP:1:OFF
5.4.2
Using test mode on the FXO and FXS ports
FXO and FXS ports can be set to test mode, during which you can:
•
Set and view the transmit and receive ABCD signaling bits
•
Set the tip and ring leads
•
View the tip and ring statistics
To use test mode, you must first enable it. For example, to enable test mode on port 1, enter
the following command:
the following command:
user>
SET FXSTST:TEST:1:ON
To exit test mode, enter the OFF command:
user>
SET FXSTST:TEST:1:OFF
5.4.2.1
Setting or viewing the transmit ABCD signaling bits
The TxAB (Transmit ABCD) parameter enables you to either monitor the status of the ABCD
signaling bits being transmitted towards the network or set a specific ABCD pattern for testing
the transmit side of the circuit.
signaling bits being transmitted towards the network or set a specific ABCD pattern for testing
the transmit side of the circuit.
To specify a transmit ABCD bit pattern on an FXO port, enter the following command:
user>
SET FXOTST:TXAB:n:(00/01/10/11)
To specify a transmit ABCD bit pattern on an FXS port, enter the following command:
user>
SET FXSTST:TXAB:n:(00/01/10/11)
To view the transmit ABCD bit pattern being used on an FXO port, enter the following
command:
command:
user>
GET FXOTST:TXAB:n
To view the transmit ABCD bit pattern being used on an FXS port, enter the following
command:
command:
user>
GET FXSTST:TXAB:n