Promise Technology TX4000 ユーザーズマニュアル

FastTrak TX4000 User Manual 

 

 

12 

Under the Security setting, FastTrak TX4000 permits two drives to be used for a 
single Mirrored array or four drives to be used for a Mirrored/Striped array in 
Auto Setup. 

You would use this method if you wish to use a drive that already contains data 
and/or is the bootable system drive in your system. You will need another drive 
of identical or larger storage capacity.  

 

If creating a Security array using an existing hard drive, backup 
any necessary data. Failure to follow this accepted PC practice 
could result in data loss. 

 

 

If you wish to include your current bootable drive using the 
Windows NT 4.x, 2000, XP, Server 2003, ME or 98 operating 
system as part of a bootable Mirrored (RAID 1) array on your 
FastTrak TX4000, do NOT connect the hard drive to the 
FastTrak TX4000 controller yet.  
You MUST install the Windows NT 4.x, 2000, XP, Server 2003, 
ME or 98 driver software first (see Chapter 4) to this drive while it 
is still attached to your existing hard drive controller. 

 

Follow these steps: 

1. 

Using the Spacebar, choose Security under the Optimize Array for section.   

2. 

Press Ctrl-Y to Save your selection. The window below will appear.  

Do you want the disk image to be duplicated to another? (Yes/No) 
Y - Create and Duplicate 
N - Create Only 

3. 

Press Y for the Create and Duplicate option. The window below will appear 
asking you to select the Source drive to use. FastBuild will copy all data 
from the Source drive to the Target drive.