JVC KD-LHX601 ユーザーズマニュアル

40

You can set the speaker output balance, subwoofer
output level, and input level of each source.

• There is a time limit in doing the following

procedure. If the setting is canceled before you
finish, start from step 

1 again.

The next-step-operation
buttons start flashing.
Each time you press the
button, the adjustable items
change as follows:

• For iEQ (sound mode) settings,

see pages 41 – 43.

• For THEME (display theme) settings,

see page 44.

Fad

Adjust the front

R06 (Rear only)

and rear speaker

   |

balance.

F06 (Front only)

Bal

Adjust the left

L06 (Left only)

and right speaker    |
balance.

R06 (Right only)

Sub Out

Adjust the

00 (min.)

subwoofer output    |
level and cutoff

08 (max.)

frequency level.

Low/Mid/High

Vol Adj

Adjust and store

–05 (min.)

the input level

   |

of each source.

+05 (max.)

You can make these two adjustments at
the same time.
• If you are using a two-speaker system,

set the fader level to “00.”

• Press 

5 (up) or ∞ (down)

to adjust the fader.

• Press 

¢   or 4 

to adjust the balance.

This takes effect only when a subwoofer is
connected.

You can also set an appropriate cutoff
frequency level according to the subwoofer
connected.

• Press 

¢   or 4   to select “Low,”

“Mid,” or “High.”

Low:

Frequencies higher than 55 Hz are
cut off to the subwoofer.

Mid:

Frequencies higher than 85 Hz are
cut off to the subwoofer.

High: Frequencies higher than 115 Hz are

cut off to the subwoofer.

To decrease the level

To increase the level

EN40-44_KD-LHX601[E_EX].p65

04.1.15, 2:32 PM

40