HP (Hewlett-Packard) HP RP7405/7410 ユーザーズマニュアル
Chapter 2
Installation
Unpacking the Server
26
Unloading with Lift Handle Panels
WARNING
Use this procedure only if no Hewlett-Packard approved lift is available. This
procedure should only be attempted by two (2) authorized Hewlett-Packard service
people.
procedure should only be attempted by two (2) authorized Hewlett-Packard service
people.
Before attempting this procedure, it is recommended that you first remove all Cell
Boards and AC power supplies. Instructions for removing these components can be
found in the Removal and Replacement chapter of the service manual. Check with
local safety regulations before attempting to move the system using the lift handle
panels.
Boards and AC power supplies. Instructions for removing these components can be
found in the Removal and Replacement chapter of the service manual. Check with
local safety regulations before attempting to move the system using the lift handle
panels.
Failure to observe these precautions can cause serious injury to personnel or
damage to equipment.
damage to equipment.
CAUTION
Unpack the server in an ESD safe environment. Observe all ESD safety precautions before
attempting this procedure. Failure to follow ESD safety precautions could result in damage to
the server.
attempting this procedure. Failure to follow ESD safety precautions could result in damage to
the server.
Step 1. Remove both side covers. If present, remove the front panel.
Step 2. Locate lift handles and remove from storage plate.
Step 3. Orient lift handle panels such that when installed, the handles hang downward at 90 degrees and
lock in a horizontal position during lifting.
Figure 2-10 Positioning the Lift handles