HP (Hewlett-Packard) HSC/PCI 1000Base-SX ユーザーズマニュアル
Gigabit Ethernet Resources
HP-UX Manual Reference Pages
Chapter 3
20
HP-UX Manual Reference Pages
While installing, configuring, or troubleshooting Gigabit Ethernet, you may need to refer
to any of the following online manual reference pages (man pages) for useful HP-UX
operating system or Gigabit Ethernet commands. To display a man page, type the
following at the system prompt:
to any of the following online manual reference pages (man pages) for useful HP-UX
operating system or Gigabit Ethernet commands. To display a man page, type the
following at the system prompt:
man
command name. For example,
man arp
.
•
arp(1M)
displays and modifies the Internet-to-station address mapping tables used
by the Address Resolution Protocol.
•
hosts
(4) is a database that contains a single line entry for each host name entry.
•
ifconfig(1M
) assigns an address to a network interface and configures and displays
network parameters.
•
ioscan(1M)
scans system hardware, usable I/O system devices, or kernel I/O system
data structures as appropriate, and lists the results.
•
lanadmin(1M)
resets or reports the status of the LAN card.
•
lanconfig(1M)
in HP-UX 10.20 sets/resets the packet encapsulation method for a
network interface.
•
lanscan(1M)
displays information about LAN cards that are successfully bound to
the system.
•
linkloop(1M)
verifies network connectivity through the Data Link Layer (OSI
Layer 2).
•
netfmt(1M)
formats common tracing and logging binary files.
•
netstat(1)
provides network statistics and information about network connections.
•
nettl(1M)
logs network events and traces packets as they enter and exit the Gigabit
Ethernet driver.
•
ping(1M)
verifies network connectivity through the Network Layer (OSI Layer 3)
and reports the round-trip time of communications between the local and remote
hosts.
hosts.
•
rad(1M)
in HP-UX 11i performs OLA/R functions without any comprehensive
checks.
•
route(1M)
adds and deletes entries to the network routing table.
•
sam(1M)
configures networking software.
•
swinstall(1M)
loads software filesets.
•
swverify(1M)
verifies software installation.