HP (Hewlett-Packard) 600N ユーザーズマニュアル

 

EN

TCP/IP Configuration 33

Dynamic Host Configuration Protocol (DHCP, RFC 2131/2132) is 
one of several auto configuration mechanisms that the HP JetDirect 
print server uses. If you have a DHCP server on your network, the 
HP JetDirect print server automatically obtains its IP address from 
that server and registers its name with any RFC 1001 and 
1002-compliant dynamic name services.

DHCP services must be available on the server. 
Refer to your system documentation or online help 
to install or enable DHCP services.

If the JetDirect print server and BOOTP/DHCP 
server are located on different subnets, IP 
configuration may fail unless the routing device 
supports “BOOTP Relay” (allows the transfer of 
BOOTP requests between subnets).

telnet:

If set to 0, this parameter instructs the print server not to 
allow incoming Telnet connections. To regain access, 
change the setting in the TFTP configuration file and 
power cycle the print server, or cold reset the print server 
to factory default values. If this parameter is set to 1, 
incoming Telnet connections are allowed. 

port:

For multiport JetDirect print servers, identifies the port (1, 
2, or 3) for port-specific commands. The default is 1.

banner:

A port-specific parameter that specifies printing an LPD 
banner page. 0 disables banner pages. 1 (default) 
enables banner pages.