Motorola W24 ユーザーズマニュアル

The W24 incorporates 2 mechanical holes for installing the module onto the application board. 
The holes are 2.4 millimeters in diameter, which accommodates several types of mechanical 
elements.

Several mechanical approaches may be applied to mount and fasten W24 to the application board. 
Using M2 screws with suitable washers to mount the module onto spacers, a bracket or chassis is 
a recommended design.

Special attention must be paid to the area surrounding the W24 mounting holes. A grounding pad 
of 4.4 millimeters in diameter surrounds these holes. The diameter and area of this pad must not 
be exceeded by any mechanical or electrical element.

Several electrical components, which are not shielded, are located near the holes.

These components must not be in contact with the mounting elements or with other parts of the 
application board, and care must be taken to avoid any damage.

 depict the W24 mounting area.

The holes are used for mechanical mounting of W24 to the application board but also for 
grounding support. Using conductive elements to install W24, significantly improves the overall 
grounding of the module and therefore improves the W24 performance and stability.

It is required to use screws or other mechanical elements to fasten W24 to the application board, 
but it is highly recommended to use conductive elements to improve the module's performance.

The preferred mounting screw head types are:

"Allen" head with a champer - the best choice.

"Torx" head - good.

"Philips" head - may cause damage to nearby components.

Recommended screw type for static products: M2x4, PAN, SST