Motorola LPCI810 ユーザーズマニュアル
Section 2
Installation
PAGE 6
LPCI810
Manually Installing the Driver
You can also install the software driver necessary for your Ethernet Adapter manually. This
installation sequence assumes you have already installed the Ethernet Adapter into your
computer. If you have not, please refer to
installation sequence assumes you have already installed the Ethernet Adapter into your
computer. If you have not, please refer to
for instructions
on physically installing the Ethernet Adapter.
What follows are generic instructions, your operating system may differ slightly, but the
overall procedure is similar.
overall procedure is similar.
1 After you have installed the Ethernet Adapter and re-powered your computer, the Found
New Hardware window is displayed:
After a few moments, if the New Hardware Wizard does not automatically appear, click
Start > Setttings > Control Panel > Add/Remove Hardware. The Add/Remove
Hardware window is displayed:
Start > Setttings > Control Panel > Add/Remove Hardware. The Add/Remove
Hardware window is displayed:
2 Click Next.