Motorola MVME172 ユーザーズマニュアル
Functional Description
http://www.mcg.mot.com/literature
3-3
3
BBRAM Interface
The MC2 chip provides a read/write interface to the BBRAM by any bus
master on the MC68060 bus. The BBRAM interface operates identically
to the Flash in that it performs dynamic sizing for accesses to the 8-bit
BBRAM to make it appear contiguous. This feature allows code to be
executable from the BBRAM. Burst accesses to Flash/PROM are inhibited
by the interface so that they are broken into four longword accesses. The
BBRAM device access time must be no greater than 5 BCLK periods in
fast mode or 9 BCLK periods in slow mode. The BBRAM speed option is
controlled by control bit 8 in the General Control Register at address
$FFF42000 in the MC2 chip.
master on the MC68060 bus. The BBRAM interface operates identically
to the Flash in that it performs dynamic sizing for accesses to the 8-bit
BBRAM to make it appear contiguous. This feature allows code to be
executable from the BBRAM. Burst accesses to Flash/PROM are inhibited
by the interface so that they are broken into four longword accesses. The
BBRAM device access time must be no greater than 5 BCLK periods in
fast mode or 9 BCLK periods in slow mode. The BBRAM speed option is
controlled by control bit 8 in the General Control Register at address
$FFF42000 in the MC2 chip.
82596CA LAN Interface
The LAN controller interface is described in the following sections.
MPU Port and MPU Channel Attention
The MC2 chip allows the MC68060 bus master to communicate directly
with the Intel 82596CA LAN Coprocessor by providing a map decoder
and required control and timing logic. Two types of direct access are
feasible with the 82596CA: MPU Port and MPU Attention.
with the Intel 82596CA LAN Coprocessor by providing a map decoder
and required control and timing logic. Two types of direct access are
feasible with the 82596CA: MPU Port and MPU Attention.
MPU Port access enables the MPU to write to an internal, 32-bit 82596CA
command register. This allows the MPU to do four things:
command register. This allows the MPU to do four things:
1. Write an alternate System Configuration Pointer address.
2. Write an alternative dump area pointer and perform a dump.
3. Execute a software reset.
4. Execute a selftest.
Each Port access must consist of two 16-bit writes: Upper Command Word
(two bytes) and Lower Command Word (two bytes). The Upper Command
Word (two bytes) is mapped at $FFF46000 and the Lower Command
Word (two bytes) is mapped at $FFF46002.
(two bytes) and Lower Command Word (two bytes). The Upper Command
Word (two bytes) is mapped at $FFF46000 and the Lower Command
Word (two bytes) is mapped at $FFF46002.
The MC2 chip only supports (decodes) MPU Port writes. It does not
decode MPU Port reads. (Nor does the 82596CA support MPU Port reads.)
decode MPU Port reads. (Nor does the 82596CA support MPU Port reads.)