ZyXEL Communications PLA-402 v2 ユーザーズマニュアル

Chapter 4 The ENCRYPT Button

PLA-4xx Series User’s Guide

Figure 17   ENCRYPT Connection Procedure 

5 Repeat step 

 in this section for the other powerline device you wish to connect. This 

must be done within 120 seconds of pressing the ENCRYPT button on the PLA-4xx.

6 Check the lights on the two powerline devices. The power (

) and HomePlug (

) 

lights should be blinking while the devices are connecting. Several times all lights blink 
simultaneously and the HomePlug (

) light also shows red. Wait for about one minute 

while your powerline devices connect. 

V

If the power (

) light does not blink when you press ENCRYPT, you have 

probably pressed the ENCRYPT button for too long. Try again, pressing the 
ENCRYPT button for 1~ 2 seconds. 

V

If the HomePlug (

) lights on both powerline devices do not light up, the 

powerline devices are not connected. Repeat steps 4 and 5 in this section. If 
that doesn’t work, see the Troubleshooting in Section 7.5 on page 68 for 
suggestions. 

7 To add more powerline devices to your network, press the ENCRYPT button on device 

C (shown below) for more than 10 seconds until the power (

) light flashes. 

8 Then repeat steps 

 and 

 in this section using any powerline device (A or B) you have 

connected using ENCRYPT and the powerline device you want to connect (C). You 
must use the ENCRYPT button on both devices.