ZyXEL Communications G-202 ユーザーズマニュアル

ZyXEL G-202 User’s Guide

Chapter 2 Tutorial

25

The following sections show you how to join a wireless network using the ZyXEL utility, as in 
the following diagrams. The wireless client is labeled C and the access point is labeled AP. 

Figure 7   Infrastructure Network

There are three ways to connect the wireless client (the G-202 in station mode) to a network.

• Configure nothing and leave the wireless client to automatically scan for and connect to 

any available network that has no wireless security configured.

• Manually connect to a network (see 

• Configure a profile to have the wireless client automatically connect to a specific network 

or peer computer (see 

). 

This chapter also includes a simple example of how to configure the G-202 as an AP using the 
ZyXEL utility. See 

 for more information.

This example illustrates how to manually connect your wireless client to an access point (AP) 
which is configured for WPA-PSK security and connected to the Internet. Before you connect 
to the access point, you must know its Service Set IDentity (SSID) and WPA-PSK pre-shared 
key. In this example, the SSID is “SSID_Example3” and the pre-shared key is 
“ThisismyWPA-PSKpre-sharedkey” in the AP. 

After you install the ZyXEL utility and then insert the wireless client, follow the steps below 
to connect to a network using the Site Survey screen. 

1 Open the ZyXEL utility and click the Site Survey tab to open the screen as shown next.