Multi-Tech Systems MTS2SA-T ユーザーズマニュアル

Chapter 13 – SMTP Client

Multi-Tech Systems, Inc. MultiConnect Serial-to-Serial Adapter User Guide (S000354A)

147

Scenario 3 – Sending a Text Email Using
Configuration and Interactive Mode

•

The to-addresses, cc-addresses, and subject taken from the configuration and

•

The message body is entered in interactive mode.

To support this scenario, you must configure the following details in addition to the mandatory
configuration

•

Set subject data of maximum length 255 characters.
Command: set send-mail subject subject data

•

Set to-addresses of maximum length 64 characters.
Command: set send-mail to-address 1 <email-id #1>

set send-mail to-address 2 <email-Id#2>

•

Set cc-addresses of maximum length 64 characters.
Command: set send-mail cc-address 1 <email-ID#3>

set send-mail cc-address 2 <email-ID#4>

Issue the following command at the serial command prompt: #send-mail

The SMTP session then enters into interactive mode and requests that the message body be entered as
shown in the figure below. After completing the message, type Ctrl+D to end the message.

The email is sent only to pre-configured recipients. The subject is also taken from the configuration.

Notes:

The email is sent to addresses pre-configured using set commands.

At least one address, either the to-address or the cc-address, should be configured

using set commands; otherwise, the SMTP session enters into interactive mode
prompting you to enter the required details.

3. If

the

subject option is not specified or is not pre-configured using set commands, SNMP

enters into interactive mode and requests a subject to be entered.

4. Type

Ctrl+C to quit the email at any given time.