Multi-Tech Systems MTS2SA-T ユーザーズマニュアル
Chapter 14 – POP3 Client
Multi-Tech Systems, Inc. MultiConnect Serial-to-Serial Adapter User Guide (S000354A)
159
Scenario 8 – Sending a Mime Encoded Binary
Email Using Interactive Mode
Email Using Interactive Mode
Issue the following command:
send-mail -b
The SMTP session then enters into interactive mode requesting the to-address, the cc-address,
subject, and message body to be entered. After completion of the message, type Ctrl+D to end the
message.
subject, and message body to be entered. After completion of the message, type Ctrl+D to end the
message.
The SMTP session enters into interactive mode requesting media-type, media-subtype, filename, filesize,
and the attachment body as shown in the figure.
and the attachment body as shown in the figure.
When the attachment body reaches the filesize, another message is displayed asking whether to continue
with one more attachment. Type n for No. The email with its attachment is sent only to the entered to-
addresses (if any) and cc-addresses (if any). The subject and message body are used as entered in
the interactive mode.
with one more attachment. Type n for No. The email with its attachment is sent only to the entered to-
addresses (if any) and cc-addresses (if any). The subject and message body are used as entered in
the interactive mode.
Notes:
1.
The email is sent only to addresses entered in interactive mode.
2.
If the subject is pre-configured using set commands, it will be used as the subject for the email.
3.
Type Ctrl+C to quit the email at any given time.
4.
If the host wants to quit the email while sending the binary attachment body, type Ctrl+C and wait
for 3 seconds without entering any character to quit the email.
for 3 seconds without entering any character to quit the email.