Multi-Tech Systems MTS2SA-T ユーザーズマニュアル

Chapter 8 – Auto Dial-in Feature 

Multi-Tech Systems, Inc. MultiConnect Serial-to-Serial Adapter User Guide (S000354A) 

 

 

 

# set serial auto-telnet enable 

# set serial s0 auto-dialin enable 

# set serial s0 auto-dialin trig-mode dtr-char 

# set serial s0 auto-dialin-ipaddress 202.54.39.96 

# set serial s0 auto-dialin-port 5000 

# set serial s0 auto-dialin-protocol telnet 

 

# set serial s0 stop-bits 1 

# set serial s0 baud-rate 115200 

# set serial s0 data-bits 8 

# set serial s0 parity none 

# set serial s0 flow-control rts-cts 

 

# set serial s1 stop-bits 1 

# set serial s1 baud-rate 115200 

# set serial s1 data-bits 8 

# set serial s1 parity none 

# set serial s1 flow-control rts-cts 

# set serial s1 connect-type modem 

# set serial s1 modem dial-number 123 

 

# set serial s1 modem dialing-trig-mode none 

(Refer to the Chapter 6 Prerequisite Configurations - Physical Link Established over the Modem 

Port for more details) 
 

# set ppp ppp0 ipcp-mode client-only 

# set ppp ppp0 username "MultiConnect" 

# set ppp ppp0 password "MultiConnect" 

# save 

 

 

Once the PPP link is up with an IP address, the auto dial-in session can be probed. When 
detecting either a DTR signal or when any character is received from the serial device connected 
to the RS-232 serial port of MultiConnect IP, the Telnet client on board in the MultiConnect IP 
establishes a Telnet session to 202.54.39.96 on port 23. 

The serial tunnel between the serial device and the Telnet Server terminates in one of the 
following conditions. 

• 

The connection is broken between the serial device and the serial port of the 
MultiConnect IP.  

• 

The Telnet Client on board is terminated. 

• 

The Telnet Server terminates the session.  

You cannot open more than one Dial-in session.  

The Dial-in session is closed when the configuration session is closed (if opened). 

When escape-monitor is enabled, care should be taken during file transfer that the escape-
monitor-string is not part of the data.