Multi-Tech Systems MT3334HD8 ユーザーズマニュアル

CommPlete Communications Server

You can use the O command to bring the modem out of command mode and back into online mode. The
O 

command reverses the result of entering the escape code. The O command brings the modem into

whichever online mode (originate or answer) that it was in prior to entering command mode.

When you are online with another Multi-Tech modem, you can issue AT commands to it by sending a
remote configuration escape sequence. The remote modem responds by displaying a menu and asking for a
setup password. The MT3334HD8 has two default passwords. Please note that if you change them, you
cannot retrieve them by resetting the modem by using AT&W1; you must know the new passwords to
make any further changes. For further information on remote configuration, see Appendix F, “Remote
Configuration.”

Enter the remote configuration escape sequence to initiate remote configuration when you are online with
another Multi-Tech modem. The default escape sequence used by the MT3334HD8 is three percent signs
(

%%%) followed by the letters AT and E

NTER

. The remote configuration escape character, which is stored

in register S13, can be changed either locally or remotely for greater security.

xxxxxx = password
Default: #IMULTI-TECH

Use the #I command to enter or change the remote configuration login password.

xxxxxx enters the current remote configuration login password, where 

xxxxxx represents the

password. If the password is wrong, the remote modem responds with ERROR; if it is correct, the remote
modem responds with 

OK, and you can proceed with the #S command.

xxxxxx stores a new remote configuration login password, where 

xxxxxx represents the password.

The password is case sensitive, and can be any combination of upper and lower case keyboard characters.
It must be six to ten characters in length.