Multi-Tech Systems MT3334HD8 ユーザーズマニュアル

CommPlete Communications Server

  1.  Establish a remote configuration link with the remote modem as described above.

  2.  Type AT#IMULTI-TECH (or AT#Ixxxxxx if you have replaced the MULTI-TECH password with

xxxxxx) and press E

NTER

. The modem responds with OK

 if the login password is correct, and

ERROR

 if it is wrong.

  3.  Type AT#SMODEMSETUP (or AT#Syyyyyy if you have replaced the MODEMSETUP password

with 

yyyyyy) and press E

NTER

. The modem responds with OK

 if the setup password is correct, and

ERROR

 if it is wrong.

  4.  To change the login password, type AT#I=xxxxxx, where xxxxxx stands for the password, and

press E

NTER

. The password may include any keyboard characters, but must be six to ten characters long.

The modem responds with 

OK.

  5.  To change the setup password, type AT#S=yyyyyy, where yyyyyy stands for the password, and

press E

NTER

. The password may include any keyboard characters, but must be six to ten characters

long. The modem responds with 

OK.

  6.  The new passwords are saved automatically. You may now either enter more AT commands or exit

remote configuration with ATO<CR>. The next time you remotely configure the modem you must
use the new setup password.

 Passwords are case sensitive. The next time you enter the password, it must be in the same case as

you set it up.

To increase security, you may wish to change the remote modem’s remote configuration escape character.
The remote configuration escape character is stored in register S13. The factory default is 37, which is the
ASCII code for the percent character (%). Setting S13

 to 0 (zero) will disable remote configuration

entirely—but if you do this remotely, you won’t be able to change it back remotely!

  1.  Establish a remote configuration link with the remote modem as described above.

  2.  Type ATS13=n, where n is the ASCII code for the new remote configuration escape character, then

press E

NTER

.

  3.  Save the new value by typing AT&W and pressing E

NTER

.

  4.  Type ATO<CR>, then 1, to exit remote configuration.