Multi-Tech Systems MTS2SA-T-R ユーザーズマニュアル
Chapter 11 – Point-to-Point Protocol
Multi-Tech Systems, Inc. MultiConnect Serial-to-Serial Adapter User Guide (S000354A)
134
PPP Interface Related Parameters
Enabling/Disabling Authentication
This command enables or disables a PPP Authentication session . If Authentication is enabled,
then the authentication protocol, the user name, and password should also be set.
then the authentication protocol, the user name, and password should also be set.
Command:
# set ppp [interface] authentication <enable/disable>
Example:
# set ppp ppp0 authentication enable
OK
OK
Authentication Type - Protocol
This command sets the Authentication type.
Command:
# set ppp [interface] auth-type <pap/chap/pap-chap>
Example:
#set ppp ppp0 auth-type pap
OK
OK
User Name & Password for Remote Peer Authentication
This command sets the user name with which the remote server will authenticate. If
authentication is disabled, this need not be configured.
authentication is disabled, this need not be configured.
Command:
# set ppp [interface] username
# se
# se
t ppp [interface] password
Example:
# set ppp ppp0 username user1
OK
#set ppp ppp0 password user1
OK
OK
#set ppp ppp0 password user1
OK
IPCP Mode
This command sets the IPCP mode.
Command:
# set ppp [interface] ipcp-mode <client-only/client-or-lan>
Examples:
# set ppp ppp0 ipcp-mode client-only
OK
When ipcp-mode is set to client-only, the local and remote ip addresses are set
When ipcp-mode is set to client-only, the local and remote ip addresses are set
to 0.0.0.0 automatically
# set ppp ppp0 ipcp-mode client-or-lan
OK
When ipcp-mode is set to client-or-lan, the local and remote ip addresses have
to
When ipcp-mode is set to client-or-lan, the local and remote ip addresses have
to
be
configured
Show Commands
This command allows you to view the PPP configuration settings.
Command:
#show ppp ppp0 configuration
This command allows you to view the PPP logical link status
Command:
# show ppp [interface] link-status
Example:
#show ppp ppp0 link-status
Up / Down
OK
This command allows you to view the PPP link IP address
This command allows you to view the PPP link IP address
Command:
# show ppp [interface] ip-addr
Example:
#show ppp ppp0 ip-addr
local: 192.168.2.1
remote: 192.168.2.2
OK
local: 192.168.2.1
remote: 192.168.2.2
OK