Multi-Tech Systems MTS2SA-T-R ユーザーズマニュアル
Chapter 13 – SMTP Client
Multi-Tech Systems, Inc. MultiConnect Serial-to-Serial Adapter User Guide (S000354A)
147
Scenario 3 – Sending a Text Email Using
Configuration and Interactive Mode
Configuration and Interactive Mode
•
The to-addresses, cc-addresses, and subject taken from the configuration and
•
The message body is entered in interactive mode.
To support this scenario, you must configure the following details in addition to the mandatory
configuration
configuration
•
Set subject data of maximum length 255 characters.
Command: set send-mail subject subject data
Command: set send-mail subject subject data
•
Set to-addresses of maximum length 64 characters.
Command: set send-mail to-address 1 <email-id #1>
Command: set send-mail to-address 1 <email-id #1>
set send-mail to-address 2 <email-Id#2>
•
Set cc-addresses of maximum length 64 characters.
Command: set send-mail cc-address 1 <email-ID#3>
Command: set send-mail cc-address 1 <email-ID#3>
set send-mail cc-address 2 <email-ID#4>
Issue the following command at the serial command prompt: #send-mail
The SMTP session then enters into interactive mode and requests that the message body be entered as
shown in the figure below. After completing the message, type Ctrl+D to end the message.
shown in the figure below. After completing the message, type Ctrl+D to end the message.
The email is sent only to pre-configured recipients. The subject is also taken from the configuration.
Notes:
1.
The email is sent to addresses pre-configured using set commands.
2.
At least one address, either the to-address or the cc-address, should be configured
using set commands; otherwise, the SMTP session enters into interactive mode
prompting you to enter the required details.
prompting you to enter the required details.
3. If
the
subject option is not specified or is not pre-configured using set commands, SNMP
enters into interactive mode and requests a subject to be entered.
4. Type
Ctrl+C to quit the email at any given time.