Multi-Tech Systems MTS2SA-T-R ユーザーズマニュアル
Chapter 4 – Command Line Interface (CLI)
Multi-Tech Systems, Inc. MultiConnect Serial-to-Serial Adapter User Guide (S000354A)
17
General Commands – Setup
Command Syntax
reset modem
Description
At will, reset the built-in modem.
Default Value
NA
Success
OK
Error
1. Too few arguments Possible argument(s) are modem
Command Syntax
save
Description
Command to Save the configuration to the flash and reboot.
Default Value
NA
Success
OK
Command Syntax
telnet <dial-ip-addr> [<port>]
Description
Manual serial dial-in (device port to modem port connectivity).
Invoked from the command shell.
Invoked from the command shell.
Default Value
NA
Success
OK
Error
1. Too few arguments
2. Invalid
2. Invalid
IP
address/Port
“(Error: hostp = “configured host“. Error: hostp=“configured IP address“
3. When invoked from Command shell connected through
Telnet
This command is not supported through Telnet
Command Syntax
Usage
Description
Provides the command semantics for all the commands.
Default Value
NA
Success
OK
Command Syntax
user add <user-name> [<passwd>]
Description
Add the user name and the password to the group.
Notes:
Default Groups: admin, users
Default Users: admin, ipmodule
Only Admin can configure the MultiConnect IP
Default Users: admin, ipmodule
Only Admin can configure the MultiConnect IP
Default Value
NA
Success
OK
Error
1. Too few arguments
“Too few arguments. Possible value(s) are username followed by
password“
password“
2. Unable to add the user name: “user ‘username‘ exists“
Command Syntax
user delete <user-name>
Description
Delete the user name from the group.
Default Value
NA
Success
OK
Error
1. Too few arguments
“Too few arguments. Possible value(s) are username followed by
password“
2. Unable to delete the user name: “user ‘username‘ does not exist“
password“
2. Unable to delete the user name: “user ‘username‘ does not exist“