Multi-Tech Systems MTS2SA-T-R ユーザーズマニュアル
Chapter 4 – Command Line Interface (CLI)
Multi-Tech Systems, Inc. MultiConnect Serial-to-Serial Adapter User Guide (S000354A)
32
Serial Commands – Setup
Command Syntax
set serial [s0] auto-dialout-port <port_num>
Description
If auto-dialout is enabled, specifies the auto dialout-port on which the client
can connect.
Default is 5000.
can connect.
Default is 5000.
Note:
The port number should be other than standard TCP ports.
This command is valid only for device port S0.
Default Value
5000
Success
OK
Error
1. Too few arguments
“Usage: set serial s0 auto-dialout-port <port_num>
Type ‘set serial s0 auto-dialout-port ? for more information”
2. Multiple matches
auto-dialin auto-dialin-protocol auto-dialout-protocol
auto-dialin-ipaddress auto-dialout
auto-dialin-ipaddress auto-dialout
auto-dialin-port auto-dialout-port
3. Invalid Port Number
“error: Invalid port number
Type ‘set serial s0 auto-dialout-port ? for more information”
4. If “set serial s1 auto-dialout-port 5000” is given
“error: Command not supported on modem port s1”
“error: Command not supported on modem port s1”
Command Syntax
set serial [s0] auto-dialout-protocol <telnet/>
Description Note:
This syntax gives a provision for future extensibility. <SSH Server, etc>.
This command is valid only for device port S0.
This command is valid only for device port S0.
Default Value
Telnet
Success
OK
Error
1. Too few arguments
“Usage: set serial s0 auto-dialout-protocol <telnet/>
Type ‘set serial s0 auto-dialout-protocol ?’ for more information”
2. Multiple matches
auto-dialin auto-dialin-protocol auto-dialout-protocol
auto-dialin-ipaddress auto-dialout
auto-dialin-ipaddress auto-dialout
auto-dialin-port auto-dialout-port
3. Invalid string
error:
error:
Invalid
parameter
Type ‘set serial s0 auto-dialout-protocol ?’ for more information”
4. If “set serial s1 auto-dialout-protocol telnet” is given
“error: Command not supported on modem port s1”
“error: Command not supported on modem port s1”
Command Syntax
set serial [s0/s1] baud-rate <baud>
Description
Sets the serial baud rate.
Default Value
115200
Success
OK
Error
1. Too few arguments
“Usage: set serial s0/s1 baud-rate <baud>
Type ‘set serial s0/s1 baud-rate ?’ for more information”
2. Invalid baud-rate
“error: baud-rate range : [300,……]
Type ‘set serial s0/s1 baud-rate ?’ for more information”