Abocom None ユーザーズマニュアル

 

- 

 

Select an item (SSID) on the list and then click to add it into the profile list. 

Select an item (SSID) on the list and then click to make a connection. 

Access Point (AP) Information 

Double click on the intended AP to see AP's detail information that divides into four parts. They are 

General, WPS, CCX and 802.11n information. The introduction is as following: 

 

General information contain AP's SSID, MAC address, Authentication Type, 
Encryption Type, Channel, Network Type, Beacon Interval, Signal Strength 
and Supported Rates. 

Close: Click this button to exit the information screen. 

 

WPS information contains Authentication Type, Encryption Type, Config 
Methods, Device Password ID, Selected Registrar, State, Version, AP Setup 
Locked, UUID-E and RF Bands. 

Authentication Type: There are four types of authentication modes supported 
by RaConfig. They are Open, Shared, WPA-PSK, WPA securities, 
WPA2-PSK and WPA2. 

Encryption Type: For Open and Shared authentication mode, the selection of 
encryption type are None and WEP. For WPA, WPA2, WPA-PSK and 
WPA2-PSK authentication mode, the encryption type supports both TKIP and 
AES. 

Config Methods: Correspond to the methods the AP supports as an Enrollee 
for adding external Registrars. 

Device Password ID: Indicate the method or identifies the specific password 
that the selected Registrar intends to use.