Acer AcceleRAID 352 ユーザーズマニュアル
Installation
Manual No. 775051
2-15
7. Termination - Both Internal and External Devices
Check that the drive channel is properly terminated according to the
drawing below. If the controller is in the middle of the SCSI bus, it
automatically disables on-board termination. If some SCSI devices on
the channel are connected to the internal connector, and some are
connected to the external connector, on the same channel, the two
ends of the SCSI bus farthest from the controller must each be
terminated.
drawing below. If the controller is in the middle of the SCSI bus, it
automatically disables on-board termination. If some SCSI devices on
the channel are connected to the internal connector, and some are
connected to the external connector, on the same channel, the two
ends of the SCSI bus farthest from the controller must each be
terminated.
See Figure 2-12 for an example of a combined internal and external
drive configuration. Notice that they are on the same channel.
drive configuration. Notice that they are on the same channel.
☛
Note
It is better to terminate the ends of the SCSI bus itself
than it is to terminate the end devices on the bus. This
allows hot swap devices to be added or removed from
the SCSI bus without affecting termination.
than it is to terminate the end devices on the bus. This
allows hot swap devices to be added or removed from
the SCSI bus without affecting termination.
☛
Note
The only devices controlled by the RAID
configuration are the ones physically
connected to the AcceleRAID 352 controller.
configuration are the ones physically
connected to the AcceleRAID 352 controller.
Figure 2-12. Termination with Internal and External Drive Configuration
8. Remove or set disk drive termination jumpers to the disabled position
(if needed). Refer to your system documentation furnished with your
disk drives to determine if your termination jumpers need to be
adjusted.
disk drives to determine if your termination jumpers need to be
adjusted.