D-Link DAP-1350 ユーザーズマニュアル

D-Link DAP-1350 User Manual

Section 3 - Configuration

Wireless Client Mode is selected.

Click 

Site Survey to display a list of wireless networks in your 

area. You may select the wireless access point to connect to.

Select 

Infrastructure  if  connecting  to  an  access  point  or 

wireless  router,  or  select 

Ad-Hoc  if  connecting  to  another 

wireless client.

Enter the SSID of the wireless network you want to connect 
to. If you do not know for sure, click 

Site Survey and select it 

from the list, if available.

The channel will automatically change to the channel of the AP 
you are connected to. 

Select  the  appropriate  802.11  mode  based  on  the  wireless 
clients in your network. Select 

Mixed 802.11b/g, 802.11n Only, 

or 

Mixed 802.11b/g/n from the drop-down menu.

Select the Channel Width:

Auto 20/40 - Select if you are using both 802.11n and non-
802.11n wireless devices.

20MHz  -  Select  if  you  are  not  using  any  802.11n  wireless 
clients.

Select the transmission rate. It is strongly suggested to use the Auto setting for optimal performance.

You can clone the MAC address of the device connected via Ethernet to the DAP-1350. 

Select a wireless security setting. Options are 

None, WEP, WPA, or WPA2. See the Wireless Security section in this manual 

for a detailed explanation of the wireless security options.

Select enable if you want to configure the DAP-1350 with Wi-Fi Protection setup.