D-Link DAP-1350 ユーザーズマニュアル
D-Link DAP-1350 User Manual
Section 3 - Configuration
PPTP
Choose PPTP (Point-to-Point Tunneling Protocol) if your ISP uses a PPTP connection. Your ISP will provide you with
a username and password. This option is typically used for DSL services.
a username and password. This option is typically used for DSL services.
PPTP IP Address:
PPTP Subnet Mask:
PPTP Server IP Address:
Username:
Password:
Reconnect Mode:
Maximum Idle Time:
DNS Servers:
MTU:
Clone MAC Address:
Enter the IP address (Static PPTP only).
Enter the subnet mask.
Enter the Server IP Address provided by
your ISP.
your ISP.
Enter your PPTP username.
Enter your PPTP password and then retype
the password in the next box.
the password in the next box.
Select
Always on, On Demand or
Manual.
Enter the time (in minutes) where the
router will disconnect if idle for the time
specified.
router will disconnect if idle for the time
specified.
Enter the Primary and Secondary DNS
(Domain Name System) server IP address
assigned by your ISP.
(Domain Name System) server IP address
assigned by your ISP.
You may need to change the MTU (Maximum
Transmission Unit) for optimal performance
with your specific ISP. The default MTU size
is 1400.
Transmission Unit) for optimal performance
with your specific ISP. The default MTU size
is 1400.
The default MAC address is set to the MAC address on the AP (Access Point). You can click the
Clone Your PC’s MAC
Address button to replace the AP’s MAC address with the MAC address of your Ethernet card. It is not recommended
that you change the default MAC address unless required by your ISP.
that you change the default MAC address unless required by your ISP.