Lantronix 900-422 ユーザーズマニュアル
11: Monitor Mode
XPress DR+ User Guide
72
Table 11-1. Monitor Mode Commands
Command
Command Name
Function
VS x.x.x.x
Version
Queries software header record (16 bytes) of unit
with IP address x.x.x.x.
with IP address x.x.x.x.
GC x.x.x.x
Get Configuration
Gets configuration of unit with IP address x.x.x.x as
hex records (120 bytes).
hex records (120 bytes).
SC x.x.x.x
Send Configuration
Sets configuration of unit with IP address x.x.x.x
from hex records.
from hex records.
PI x.x.x.x
Ping
Pings unit with IP address x.x.x.x to check device
status.
status.
AT
ARP Table
Shows the unit’s ARP table entries.
TT
TCP Connection
Table
Table
Shows all incoming and outgoing TCP connections.
NC
Network Connection
Shows the unit’s IP configuration.
RS
Reset
Resets the unit’s power.
QU
Quit
Exits diagnostics mode.
G0, G1, ....,Ge, Gf
Get configuration
from memory page
from memory page
Gets a memory page of configuration information
from the device.
from the device.
S0, S1,...,Se, Sf
Set configuration to
memory page
memory page
Sets a memory page of configuration information
on the device.
on the device.
GM
Get MAC address
Shows the unit's 6-byte MAC address.
SS
Set Security record
Sets the Security record without the encryption key
and length parameters. The entire record must still
be written, but the encryption-specific bytes do not
need to be provided (they can be null since they
are not overwritten).
and length parameters. The entire record must still
be written, but the encryption-specific bytes do not
need to be provided (they can be null since they
are not overwritten).
Responses to some of the commands are in Intel Hex format.
Note:
Entering any of the commands listed above generates one of the following
command response codes:
Table 7-2. Command Response Codes
Response
Meaning
0>
OK; no error
1>
No answer from remote device
2>
Cannot reach remote device or no answer
8> Wrong
parameter(s)
9> Invalid
command