Motorola 3397GP ユーザーズマニュアル
147
Step Mode: A CLI Configuration Technique
The Motorola Netopia® Gateway command line inter face includes a step mode to automate the pro-
cess of entering configuration settings. When you use the CONFIG step mode, the command line inter-
face prompts you for all required and optional information. You can then enter the configuration values
appropriate for your site without having to enter complete CLI commands.
cess of entering configuration settings. When you use the CONFIG step mode, the command line inter-
face prompts you for all required and optional information. You can then enter the configuration values
appropriate for your site without having to enter complete CLI commands.
When you are in step mode, the command line inter face prompts you to enter required and optional
settings. If a setting has a default value or a current setting, the command line inter face displays the
default value for the command in parentheses. If a command has a limited number of acceptable val-
ues, those values are presented in brackets, with each value separated by a ver tical line. For example,
the following CLI step command indicates that the default value is
settings. If a setting has a default value or a current setting, the command line inter face displays the
default value for the command in parentheses. If a command has a limited number of acceptable val-
ues, those values are presented in brackets, with each value separated by a ver tical line. For example,
the following CLI step command indicates that the default value is
off
and that valid entries are lim-
ited to
on
and
off
.
option (off) [on | off]:
on
You can accept the default value for a field by pressing the Return key. To use a different value, enter it
and press Return.
and press Return.
You can enter the CONFIG step mode by entering
set
from the top node of the CONFIG hierarchy. You
can enter step mode for a par ticular ser vice by entering
set
service_name
.
In stepping set mode
(press Control-X <Return/Enter> to exit. For example:
Netopia-3000/9437188 (top)>>
set system
...
system
name (“Netopia-3000/9437188”):
system
name (“Netopia-3000/9437188”):
Mycroft
Diagnostic Level (High):
medium
Stepping mode ended.
Validating Your Configuration
You can use the
validate
CONFIG command to make sure that your configuration settings have
been entered correctly. If you use the
validate
command, the Motorola Netopia® Gateway verifies
that all required settings for all ser vices are present and that settings are consistent.
Netopia-3000/9437188 (top)>>
validate
Error: Subnet mask is incorrect
Global Validation did not pass inspection!
Global Validation did not pass inspection!
You can use the
validate
command to verify your configuration settings at any time. Your Motorola
Netopia® Gateway automatically validates your configuration any time you save a modified configura-
tion.
tion.