Motorola 3397GP ユーザーズマニュアル

151

Your Ser vice Provider will indicate the required vpi number.

n] vci { 0 ... 65535 }

Select the vir tual channel identifier (vci) for VCC n. Your Ser vice Provider will indicate the required vci 
number.

Select the encapsulation mode for VCC n. The options are:

Your Ser vice Provider will indicate the required encapsulation mode.

Select the number of PPPoE sessions to be configured for VCC 1, up to a total of eight. The total num-
ber of 

pppoe-sessions and PPPoE VCCs configured must be less than or equal to eight.

Bridging lets the Motorola Netopia® Gateway use MAC (Ethernet hardware) addresses to for ward non-
TCP/IP traffic from one network to another. When bridging is enabled, the Motorola Netopia® Gateway 
maintains a table of up to 512 MAC addresses. Entries that are not used within 30 seconds are 
dropped. If the bridging table fills up, the oldest table entries are dropped to make room for new 
entries. 

Vir tual circuits that use IP framing cannot be bridged.

☛  

For bridging in the 3341 (or any model with a USB por t), you cannot set the 

bridge option 

off, or bridge ethernet option off; these are on by default because of the USB port.

Enables or disables bridging ser vices in the Motorola Netopia® Gateway. You must enable bridging ser-
vices within the Motorola Netopia® Gateway before you can enable bridging for a specific inter face.

ppp-vcmux

PPP over ATM, VC-muxed

ppp-llc

PPP over ATM, LLC-SNAP

ether-llc

RFC-1483, bridged Ethernet, LLC-SNAP

ip-llc

RFC-1483, routed IP, LLC-SNAP

pppoe-vcmux

PPP over Ethernet, VC-muxed

pppoe-llc

PPP over Ethernet, LLC-SNAP