Motorola T2-2500 ユーザーズマニュアル
Installation
Steps
Motorola, Inc.
549453-001-00-a
Page 26 of 51
I
I
n
n
-
-
R
R
o
o
o
o
m
m
I
I
n
n
s
s
t
t
a
a
l
l
l
l
a
a
t
t
i
i
o
o
n
n
Note:
These instructions follow the Installation 1 procedure from the previous chapter. Please consult
WallPlate Installation
for variations of the installation routine.
Tools Required:
Number 2 Philips head screwdriver
Number 2 flat blade screwdriver
Number 2 flat blade screwdriver
Components provided with the m2a WallPlate:
1 – m2a WallPlate bracket and cover with circuit board
1 – 150mm (6”) RJ11 pigtail cable
1 – RJ11 blanking plug
2 – Number 6 oval head screws, 0.25”
1 – 150mm (6”) RJ11 pigtail cable
1 – RJ11 blanking plug
2 – Number 6 oval head screws, 0.25”
Components required to purchase:
Regulated 12V power supply. Use of the wrong power supply could result in damage to your WallPlate unit. Please
order a small quantity of regulated 12V power supplies from Motorola PBN to use during installation.
If you do not have the correct regulated 12V power supply –
order a small quantity of regulated 12V power supplies from Motorola PBN to use during installation.
If you do not have the correct regulated 12V power supply –
STOP
. Order a regulated 12V power supply from your
Motorola PBN sales representative.
Step 1
1. Loosen screws on wall plate approximately 6mm (1/4”)
2. Attach the bracket using the keyhole slots
3. Tighten screws until the bracket is firmly attached, do not over tighten
2. Attach the bracket using the keyhole slots
3. Tighten screws until the bracket is firmly attached, do not over tighten
Step 2
Connect 150mm (6”) cable (supplied) between m2a circuit board and existing RJ11 jack.