Motorola T2-2500 ユーザーズマニュアル

 VLANs 

 

 

 

Motorola, Inc. 

549453-001-00-a 

Page 30 of 51 

Tag based mode is fully 802.1Q VLAN compliant.  You must explicitly configure the 
Egress and Ingress rules for each port and each VLAN.  On the webUI, use the 802.1Q 
TAG-BASED VLAN menu to configure VLANs. 
 
The mT2 Switch and m2 WallPlate can operate independently.  Be sure to configure all 
ports on the Switch and the WallPlates for proper operation.  Consult one of the VLAN 
Tutorials. 

Port based VLAN is also called Port Isolation or Port Privacy in other switches. 
 
When operating in port-based mode, the T2 Switch will ignore 802.1Q VLAN tags.  Port 
isolation is based on a VLAN Map.  On the webUI, use the PORT-BASED menu to see 
the VLAN Map and change the mapping.  See below for more details. 
 
Note:

  The Switch operates in port-based mode; whereas the WallPlates only operate 

in tag-based, or disabled.  This allows for special case configurations where the 
WallPlates do all the 802.1Q VLAN tagging, while the Switch maintains port-to-port 
privacy. 

 

V

V

L

L

A

A

N

N

 

 

c

c

o

o

m

m

m

m

a

a

n

n

d

d

s

s

 

 

i

i

n

n

 

 

m

m

T

T

2

2

 

 

All VLAN configurations are also available from the webUI. 
 
 
vlan config default 

Restore VLAN configuration to default 

Enable or disable VLAN support.  Requires a system reboot after issuing this command. 

Create or modify a VLAN. 

Delete a VLAN Group.  Remove all ports that are members of the group before deleting 
the group. 

Enter a friendly name for the VLAN 

Add or delete a VLAN from a port.  Allows the VLAN to transmit on the port 

Sets how a VLAN will egress; with a tag or without.  By default, packets will transmit 
untagged unless specified using this command.  Note this command does NOT apply to 
WallPlate ports 

Deletes a port from a VLAN membership 

Ingress command:  Assign the PVID for a port.  This VLAN ID will be assigned to all 
packets received untagged on this port 

Set the Egress mode on any CPE port.  This command does not apply to mT2 Switch 
ports 

Assign VLAN for IGMP packets 

Assign VLAN for layer 2 security for all management traffic 

Set the mode of operation on the Switch and the WallPlates.  Options are IEEE 802.1Q 
tag-based, or Port-based.  Note:  WallPlates only support tag-based or disabled.