Motorola 3352N ユーザーズマニュアル
105
Configuring for Bridge Mode
1.
Browse into the Motorola Netopia® Gateway’s web interface.
2.
Click on the
Configure
button in the upper Menu bar.
3.
Click on the
LAN
link.
The LAN page appears.
4.
In the box titled LAN IP Interface (Ethernet
100BT):
100BT):
Make note of the Ethernet IP Address and subnet mask.
You can use this address to access the router in the future.
You can use this address to access the router in the future.
5.
Click on the
Advanced
link in the left-hand links
toolbar.
6.
Under the heading of Services, click on the
Ether-
net Bridge
link.
The Ethernet Bridge page appears.
The appearance of this page varies, depending on your
Gateway’s inter faces.
Gateway’s inter faces.
7.
If available:
a. Check the
Enable Bridging on Port selection. (This
may be Always On.)
b. Click
Submit
.
8.
If you want the Gateway to do both bridging
and routing, check the
and routing, check the
Enable Concurrent
Bridging/Routing
checkbox.
When this mode is enabled, the Gateway will appear to
be a router, but also bridge traffic from the LAN if it has
a valid LAN-side address.
be a router, but also bridge traffic from the LAN if it has
a valid LAN-side address.
9.
Check the
Enable System Bridge
checkbox.
The window shrinks.