Motorola 3352N ユーザーズマニュアル
279
set pinhole name
name protocol-select { tcp | udp }
Specifies the type of protocol being redirected.
set pinhole name
name external-port-start [ 0 - 49151 ]
Specifies the first por t number in the range being translated.
set pinhole name
name external-port-end [ 0 - 49151 ]
Specifies the last por t number in the range being translated.
set pinhole name
name internal-ip internal-ip
Specifies the IP address of the internal host to which traffic of the specified type should be transferred.
set pinhole name name internal-port [ 0 - 65535 ]
Specifies the por t number your Motorola Netopia® Gateway should use when for warding traffic of the spec-
ified type. Under most circumstances, you would use the same number for the external and internal por t.
ified type. Under most circumstances, you would use the same number for the external and internal por t.
PPPoE /PPPoA Settings
You can use the following commands to configure basic settings, por t authentication settings, and peer
authentication settings for PPP inter faces on your Motorola Netopia® Gateway.
authentication settings for PPP inter faces on your Motorola Netopia® Gateway.
Configuring Basic PPP Settings.
☛
NOTE:
For the DSL platform you must identify the vir tual PPP inter face [
vccn], a number from 1 to 8.
set ppp module [vccn] option { on | off }
Enables or disables PPP on the Motorola Netopia® Gateway.
set ppp module [vccn] auto-connect { on | off }
Suppor ts manual mode required for some vendors. The default
on is not normally changed. If auto-connect
is disabled (
off), you must manually start/stop a ppp connection.
set ppp module [vccn] mru
integer
Specifies the Maximum Receive Unit (MRU) for the PPP inter face. The integer argument can be any num-
ber between 128 and 1492 for PPPoE; 1500 other wise.
ber between 128 and 1492 for PPPoE; 1500 other wise.