Netgear WAG102NA ユーザーズマニュアル
ProSafe Dual Band Wireless Access Point WAG102 Reference Manual (802.11a/g)
3-8
Management
v2.0, September 2006
To view the Wireless Station List:
1. From the main menu of the browser interface, under the Information heading, select Available
Wireless Station List.
2. Click Refresh to update the list.
Upgrading the Wireless Access Point Software
The software of the WAG102 Wireless Access Point is stored in FLASH memory, and can be
upgraded as new software is released by NETGEAR. Upgrade files can be downloaded from
Netgear's Web site. If the upgrade file is compressed (.ZIP file), you must first extract the image
(.RMT) file before sending it to the wireless access point. The upgrade file can be sent using your
browser.
upgraded as new software is released by NETGEAR. Upgrade files can be downloaded from
Netgear's Web site. If the upgrade file is compressed (.ZIP file), you must first extract the image
(.RMT) file before sending it to the wireless access point. The upgrade file can be sent using your
browser.
You cannot perform the software upgrade from a computer that is connected to the WAG102
Wireless Access Point with a wireless link. You must use a computer that is connected to the
WAG102 Wireless Access Point with an Ethernet cable.
Wireless Access Point with a wireless link. You must use a computer that is connected to the
WAG102 Wireless Access Point with an Ethernet cable.
Figure 3-5
Tip: If the wireless access point is rebooted, the table data is lost until the wireless
access point rediscovers the devices. To force the wireless access point to look
for associated devices, click the Refresh button.
for associated devices, click the Refresh button.
Note: The Web browser used to upload new firmware into the WAG102 must support
HTTP uploads, such as Microsoft Internet Explorer 6.0 or above, or Netscape
Navigator 4.78 or above.
Navigator 4.78 or above.