Netgear CG814M ユーザーズマニュアル

2-8

Connecting the Gateway to the Internet

To connect the power adapter to the gateway:

1.

Plug the connector of the power adapter into outlet on the rear panel of the modem.

2.

Plug the other end of the adapter into an AC power outlet.

3.

Verify that the PWR LED on the modem is lit.

After applying power to the gateway, complete the following steps to verify that power is correctly 
applied:

1.

When power is first applied, verify that the Power LED comes on.

All the numbered LAN LEDs will be briefly tested.

2.

After approximately 10 seconds, verify that the local Ethernet or USB port LED is lit for the 
port that is connected to your computer.

If a port’s LED is lit, a link has been established to the connected device. If a local Ethernet port is 
connected to a 100 Mbps device, verify that the port’s LED is green. If the port is 10 Mbps, the 
LED should be yellow.

1.

Turn on the gateway.

2.

Now, turn on your computer. 

Note: If you usually run software to log in to your Internet connection, do not run that 
software.

To connect to the gateway, your computer needs to be configured to obtain an IP 

address automatically via DHCP. Please refer to 

 

for instructions on how to do this.