Netgear CG814M ユーザーズマニュアル

3-4

Wireless Configuration

The Wireless Access window displays a list of MAC addresses that will be allowed to connect to 
the gateway. These PCs must also have the correct SSID and WEP settings. To restrict access 
based on MAC addresses:

1.

Click the Add button to go to the Add/Edit menu.

For your convenience, this menu displays a list of currently active wireless cards and their 
MAC addresses.

2.

If the desired PC appears in the list, you can click on it to capture its MAC address; otherwise, 
you can manually enter the MAC address of the authorized PC.

 

The MAC address is usually printed on the wireless card.

3.

If no Device Name appears, you can type a descriptive name for the PC that you are adding.

4.

Click Add.

5.

When you have finished entering MAC addresses, return to the Wireless Access List menu 
and check the Turn Access Control On box, then click Apply.

To edit a MAC address from the table, click on it to select it, then click the Edit or Delete button.

In the Wireless Settings menu you can configure WEP data encryption from the Security 
Encryption (WEP) section using the following parameters:

•

Encryption Mode

 

Select the WEP Encryption level:
•

Off - no data encryption (Open System)

•

64-bit (sometimes called 40-bit) encryption

•

128-bit encryption

•

Authentication Type

 

Select the appropriate value - "Open System" or "Shared Key." Check your wireless card's 
documentation to see what method to use.

•

Keys

 

If WEP is enabled, you can manually or automatically program the four data encryption keys. 
These values must be identical on all PCs and Access Points in your network.

If the Turn Access Control On is enabled and the Access Control List is 

blank; then all wireless PCs will be unable to connect to your wireless network.