Multi-Tech Systems GPRS (MTMMC-G) ユーザーズマニュアル
Chapter 13 – Specific AT Commands
Multi-Tech Systems, Inc. Wireless GSM/GPRS AT Commands (Document Number S000293I)
109
General Indications +WIND
Description:
This command provides a general mechanism to send unsolicited non-standardized indications to the
application. The indicators are:
application. The indicators are:
•
Indication of a physical change on the SIM detect pin from the connector (meaning SIM inserted,
SIM removed)
•
Indication during mobile originated call setup that the calling party is ringing.
•
Indication of the availability of the product to receive AT commands after boot.
•
NITZ indication (Network Information and Time Zone)
For each of these indications, a “bit flow” has to be indicated.
Values:
<IndLevel>
0
No unsolicited “+WIND: <IndNb>” will occur.
Default.
1 (bit-0)
Hardware SIM Insert/Remove indications or SIM presence after software reset.
2 (bit-1)
Calling party alert indication.
4 (bit-2)
Product is ready to process AT commands (except phonebooks, AOC, SMS), but
still in emergency mode.
still in emergency mode.
8 (bit-3)
The product is ready to process all AT commands at the end of init or after
swapping to ADN in case of FDN configuration
swapping to ADN in case of FDN configuration
16 (bit-4)
A new call identifier has been created (after an ATD command, +CCWA indication)
32 (bit-5)
An active, held or waiting call has been released by network or other party
64 (bit-6)
Network service available indication
128 (bit-7)
Network lost indication
256 (bit-8)
Audio ON indication
512 (bit-9)
SIM phonebooks reload status
1024 (bit-10) SIM phonebooks checksum indication
2048 (bit-11) Interruption indication (only if FTR_INT is activated)
4096 (bit-12) Hardware rack open/closed indication
8192 (bit-13) NITZ
2048 (bit-11) Interruption indication (only if FTR_INT is activated)
4096 (bit-12) Hardware rack open/closed indication
8192 (bit-13) NITZ
indication
16384 (bit-14) SMS service ready indication
Combination (addition of the values) is used to allow more than one indication flow:
0 ≤ IndLevel ≤
32767
•
To activate a specific WIND indication, <IndLevel> must have a value described above.
AT+WIND=16384 only activates SMS service indication.
•
To activate several WIND indications, <IndLevel> must have a value just before the last
indication required.
AT+WIND=32767 all unsolicited indications.
<event>
0
The SIM presence pin has been detected as “SIM removed”
1
The SIM presence pin has been detected as “SIM inserted”
2
Calling party is alerting
3
Product is ready to process AT commands (except phonebooks, AOC, SMS), at init or after
AT+CFUN=1
AT+CFUN=1
4
Product is ready to process all AT commands, end of phonebook init or swap (FDN to ADN)
5
Call <idx> has been created (after ATD or +CCWA…)
6
Call <idx> has been released, after a NO CARRIER, a +CSSU: 5 indication, or after the
release of a call waiting.
release of a call waiting.
7:
The network service is available for an emergency call.
8
The network is lost.
9
Audio ON.
10
Show reload status of each SIM phonebook after init phase (after Power-ON or SIM
insertion).
insertion).
11
Show the checksum of SIM phonebooks after loading.
12
An interruption has occurred.
13
The rack has been detected as Closed.