Navionics 87043_1 ユーザーズマニュアル

ページ / 54
24
E-Series Installation Manual
How do I use the cable splicers?
The cable splicers are used to make the connections between the cables easy and 
secure, without removing insulation from cable tails. 
To use these connectors:
            
1. Place the wires to be joined into the connectors, ensuring correct polarity and that 
the wires are pushed fully home.
2. Using a pair of pliers, crimp the connector bulb together.
3. Check that a secure connection has been made.
4. Ensure that the cables are secured in a suitable position to prevent the join being 
placed under strain.
Power cable
The E-Series Display is intended for use on boats’ DC power systems 
rated at 12v or 24v.
The power connection should be made at either the output of the 
battery isolating switch, or at a DC power distribution panel. Raymarine 
recommends that power is fed directly to the display and scanner via its 
own dedicated cable system and MUST be protected by a thermal circuit 
breaker or fuse, installed close to the power connection.
This cable is supplied ready for connecting to your boats DC power supply, with a 
length of screen exposed before the positive and negative wire tails.This screen should 
be clamped to your boat’s earth/ground with a saddle clamp, as shown below:
            
cable splicer
D6615_1
Slide towards tails
Pre-cut line
Attach to ship's ground
Step 1
Step 2
D6621-2