Siemens S223 ユーザーズマニュアル

UMN:CLI                                                                                                                                                              User  Manual 

SURPASS hiD 6615 S223/S323 R1.5 

162                                                                         A50010-Y3-C150-2-7619 

To remove registered dynamic MAC addresses from the MAC table, use the following 
command. 

Clears dynamic MAC addresses. 

 NAME 

Clears dynamic MAC addresses. 

 NAME PORT 

Clears dynamic MAC addresses. 
NAME: enter the bridge name. 
PORT: enter the port number. 

 NAME PORT 

 

Enable 

Global 
Bridge 

Clears dynamic MAC addresses. 
NAME: enter the bridge name. 
PORT: enter the port number. 
MACADDR: enter the MAC address. 

 

To remove static MAC addresses manually registered by user from the MAC table, use 
the following command. 

Deletes static MAC addresses. 

 NAME 

Deletes static MAC addresses, enter the bridge name.

 NAME PORT 

Deletes static MAC addresses. 
NAME: enter the bridge name. 
PORT: enter the port number. 

 NAME PORT MACADDR 

Bridge 

Deletes a specified static MAC address. 
NAME: enter the bridge name. 
PORT: enter the port number. 
MACADDR: enter the MAC address. 

 

To display a MAC table in the switch, use the following command. 

show mac NAME

 [PORT] 

Enable 

Global 
Bridge 

Shows switch MAC address, selection by port number 
(subscriber port only): 
NAME: enter the bridge name 
PORT: select the port number. 

 

There are more than a thousand of MAC addresses in MAC table. And it is difficult to find 
information you need at one sight. So, the system shows certain amount of addresses 
displaying –more– on standby status. Press any key to search more. After you find the in-
formation, you can go back to the system prompt without displaying the other table by 
pressing <q>.