Enterasys Networks 1G58x-09 ユーザーズマニュアル
Spanning Tree Configuration Command Set
Reviewing and Setting Spanning Tree Port Parameters
6-44
Syntax Description
Command Defaults
If sid is not specified, SID 0 will be assumed.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set port cost to 25 on Fast Ethernet front panel port 11:
port-string
Specifies the port(s) to which to assign a cost value. For a
detailed description of possible port-string values, refer to
detailed description of possible port-string values, refer to
cost
Specifies a cost value. Ranges are:
•
0 to 65535 with legacy path cost enabled.
•
0 to 200000000 with legacy path cost disabled.
NOTES: A cost value of 0 will allow a port’s default
cost, which is based on link speed, to be used.
cost, which is based on link speed, to be used.
If the link is part of a trunk, the sum of all link
speeds in the trunk should be used as the cost
value.
speeds in the trunk should be used as the cost
value.
For details on the set legacypathcost command,
sid
(Optional) Sets a cost value for a specific SID.
Matrix>set spantree portcost fe.0.11 25