Planet Technology ADE-4200 ユーザーズマニュアル

ページ / 80
PLANET ADSL VPN / Firewall Router 
36 
3.6.3.4.2 Packet Filter 
When you click Packet Filter, you get the following figure. 
 
 
You may configure to filter inbound (incoming) and outbound (outgoing) packets based 
on port or IP address.  
If it is based on port, click Port Filters for more options. You may filter the packets based 
on  PORT and  packet type  (TCP  or  UDP  or  any).  For  example,  the  protocol  number  1 
means  ICMP. You may  enter 1 to  protocol number of  Raw  IP  Filtering  web  page.  Port 
ranges are supported. 
If it is based on IP address, click Address Filters for more options. You may enter the IP 
address and again to select the inbound or outbound packets. 
For  example,  to  allow  TCP  packet,  port  0  to  1000  passing  router  between  WAN  and 
LAN  and  blocks  host  IP  address,  192.168.1.100.  Then  you  have  to  configure  the  port 
filter 
à add TCP filter > 0 to 1000 and ALLOW in both direction. Then click address filter 
à add address filter à enter host IP 192.168.1.100, subnet mask 255.255.255.255 (for 
this single host) and both direction. 
 
3.6.3.4.2.1 Port Filters 
The pre-defined port filter rules for high, medium and low security level are listed below. 
When user enables Firewall Security feature for high, medium or low security level, the 
Block WAN Request function (Ping packet) is enabled automatically. 
 
Port Number 
Firewall - High 
Firewall - Medium 
Firewall - Low 
Application 
Protocol 
Start 
End 
Inbound 
Outbound 
 
Inbound  Outbound  Inbound 
Outbound 
HTTP(80) 
TCP(6) 
80 
80 
NO 
YES 
NO 
YES 
NO 
YES 
DNS (53) 
UDP(17)  53 
53 
NO 
YES 
NO 
YES 
YES 
YES 
DNS (53) 
TCP(6) 
53 
53 
NO 
YES 
NO 
YES 
YES 
YES 
FTP(21) 
TCP(6) 
21 
21 
NO 
NO 
NO 
YES 
NO 
YES 
Telnet(23) 
TCP(6) 
23 
23 
NO 
NO 
NO 
YES 
NO 
YES 
SMTP(25) 
TCP(6) 
25 
25 
NO 
YES 
NO 
YES 
NO 
YES 
POP3(110) 
TCP(6) 
110 
110 
NO 
YES 
NO 
YES 
NO 
YES