RuggedCom RX1100 ユーザーズマニュアル
RuggedRouter
User Guide
This menu allows you to make permanent changes to interfaces and to immediately
apply those changes if desired. The Save button will save changes to the permanent
configuration.
The Netmask, Broadcast, MTU, Virtual Interfaces, Proxy ARP and Media Type
controls are as described above.
The IP Address fields allow you to manually specify an IP address for this interface,
or to obtain the address from DHCP or from BOOTP.
The Activate at boot fields allow you permanently disable the interface without
actually deleting it.
The Save and Apply button applies any changes after they have been saved.
The Delete and Apply button deletes both the boot time and active interface.
The Delete button deletes the boot time interface but leaves the active interface in
existence.
apply those changes if desired. The Save button will save changes to the permanent
configuration.
The Netmask, Broadcast, MTU, Virtual Interfaces, Proxy ARP and Media Type
controls are as described above.
The IP Address fields allow you to manually specify an IP address for this interface,
or to obtain the address from DHCP or from BOOTP.
The Activate at boot fields allow you permanently disable the interface without
actually deleting it.
The Save and Apply button applies any changes after they have been saved.
The Delete and Apply button deletes both the boot time and active interface.
The Delete button deletes the boot time interface but leaves the active interface in
existence.
PPPoE On Native Ethernet Interfaces
Figure 47: List PPPoE Interfaces
This menu allows you to display and configure the PPPoE interfaces on all available
Ethernet ports.
The PPPoE Interfaces table allows you to add a PPPoE interface on an Ethernet ports
or change PPPoE interface parameters of created interfaces. Only one PPPoE
interface can be created on each Ethernet port.
The Ethernet field shows all available Ethernet ports.
The Interface Name field shows created PPPoE interfaces and provides a link to edit
the existing configuration or create a new one.
The MTU, Use Peer DNS and Default Route fields are the configured information
for PPPoE interfaces.
The Status field shows the current PPPoE link status.
Ethernet ports.
The PPPoE Interfaces table allows you to add a PPPoE interface on an Ethernet ports
or change PPPoE interface parameters of created interfaces. Only one PPPoE
interface can be created on each Ethernet port.
The Ethernet field shows all available Ethernet ports.
The Interface Name field shows created PPPoE interfaces and provides a link to edit
the existing configuration or create a new one.
The MTU, Use Peer DNS and Default Route fields are the configured information
for PPPoE interfaces.
The Status field shows the current PPPoE link status.
62 RuggedCom