RuggedCom RX1000 ユーザーズマニュアル

ページ / 284
RuggedRouter
 User Guide
Chapter 3 – Configuring The System
Introduction
This chapter familiarizes the user with:
Enabling and disabling processes such as SSH and Web Management
Changing The Password
Shutting down and Rebooting the system
Scheduling one-off and periodic commands
Examining system logs
Changing the hostname
Changing the system time and timezone
Bootup And Shutdown 
Figure 22: Bootup and Shutdown, Part 1
This menu allows you to enable/disable services and to perform actions at boot.  The 
first part of the menu manages services.  Check the box for the desired service and 
click on “Start Selected” to start the service and have it start at the next boot.  Click 
on “Stop Selected” to stop the service and not have it start at boot.
The “Reboot System” button will cause the system to reboot. 
The “Shutdown System” button shuts down the system in order to remove power.
Note:  The RuggedRouter never enters a permanent shutdown state.  If the 
RuggedRouter is instructed to shutdown, either from Webmin or from a shell command, 
it will reboot into a command line shell that waits five minutes before restarting
.  
If you really want the router to remain powered but permanently inactive, you must issue the 
shutdown, connect a terminal to the serial port, wait for the router to enter the shutdown 
shell and issue a CTRL-C. 
Once again, if you accidentally shutdown the router it will restart after five minutes.
44                                                                                                                                       RuggedCom