TP-LINK TL-WR2543ND ユーザーズマニュアル

 

- 6 - 

)

After a device is successfully added to the network by WPS function, the WPS LED will keep on 

for about 5 minutes and then turn off.   

 

Figure 1-3    Rear Panel sketch 

The following parts are located on the rear panel (View from left to right). 

¾

 

POWER: The Power socket is where you will connect the power adapter. Please use the 

power adapter provided with this TL-WR2543ND 450Mbps Dual-Band Wireless N Gigabit 

Router. 

¾

 

ON/OFF: The switch for the power. 

¾

 

There are two ways to reset to the Router's factory defaults: 

1) Use the Factory Defaults function on “System Tools  → Factory Defaults” page in the 

Router's Web-based Utility. 

2)  Use the Factory Default Reset button: With the Router powered on, use a pin to press 

and hold the Reset button (approximately 8 seconds) until the SYS LED becomes 

quick-flash from slow-flash. And then release the button and wait the Router to reboot to 

its factory default settings. 

¾

 

USB: The USB port connects to a USB storage device or a USB printer. 

¾

 

Internet: This port is where you will connect the DSL/cable Modem, or Ethernet. 

¾

 

1,2,3,4 (LAN): These ports (1, 2, 3, 4) connect the Router to the local PC(s). 

¾

 

WPS: If you have client devices, such as wireless adapters, that support Wi-Fi Protected 

Setup, then you can press this button to quickly establish a connection between the