RAD Data comm E1/T1 ユーザーズマニュアル
FCD-IPM Installation and Operation Manual
Chapter 5 Setup Menu
Routing/Bridging Menu
5-23
IPX Routing Settings
IPX ROUTING SETTINGS (Device name - FCD-IPM)
--------------------
1. LAN IPX net for frame type 802.3 - 00000000
2. LAN IPX net for frame type Ethernet II - 00000000
3. LAN IPX net for frame type 802.2 - 00000000
4. LAN IPX net for frame type SNAP - 00000000
5. Dial-in IPX net - D2162747
6. Autolearn of zero LAN IPX nets - [Enable]
7. RIP/SAP mode
ESC - Return to previous menu
Choose one of the above:
Figure 5-26. IPX Routing Settings
Select this parameter to specify parameters required for operating FCD-IPM as an
IPX router.
IPX router.
Table 5-13. IPX Routing Settings
Parameters Possible
Values
Description
LAN IPX Net for
Frame Type
Each of these parameters specifies the IPX Nets associated with a
particular frame type. If FCD-IPM is in Autolearn enable mode, then
non-zero values point to learned Net. FCD-IPM supplies default values
for these frame types that can be configured on PC's operating on LANs
for these frame types that can be configured on PC's operating on LANs
without other IPX routing.
Dial-in IPX Net
Specifies the IPX Net definition for a WAN interface
Autolearn Zero
LAN IPX Nets
LAN IPX Nets
Enable
Disable
Disable
By setting this parameter to Enable, FCD-IPM learns IPX Nets from
RIP/SAP frames sent by other IPX routers on the same LAN. Refer to
RIP/SAP frames sent by other IPX routers on the same LAN. Refer to
. If there are no other IPX routers on FCD-IPM LAN, this
parameter must be set to Disable, and you must configure the IPX Nets
for each frame type.
for each frame type.
Advanced Menu
↓
1
Setup Menu
↓
2
Routing/Bridging
↓
4
IPX Routings Settings