Atlantis Land A02-RA242-W54 ユーザーズマニュアル
WEBSHARE 242W
7
• Green for 100Mbps; Orange for 10Mbps
•
Blinking when data transmit/received.
ADSL
Lights when successfully connected to an ADSL DSLAM.
PPP
Steady glow when there is a PPPoA / PPPoE connection.
2.3 The Rear Ports
PORT
Meaning
LINE
Connect the supplied RJ-11 cable to this port when
connecting to the ADSL/telephone network.
connecting to the ADSL/telephone network.
LAN
Connect an UTP Ethernet cable to one of the four LAN ports
when connecting to a PC or an office/home network of
10Mbps or 100Mbps.
when connecting to a PC or an office/home network of
10Mbps or 100Mbps.
RESET
Recovery procedures for a lost web interface password:
After turning the router on press the Emergency/Failure
Recovery Button on the back of the modem, and hold the
button in until all lights on the modem flash and it reboots with
factory default settings. The login will be reset to admin and
the password will be reset to atlantis, and the modem will be
accessible via its default IP address at http://192.168.1.254/
After turning the router on press the Emergency/Failure
Recovery Button on the back of the modem, and hold the
button in until all lights on the modem flash and it reboots with
factory default settings. The login will be reset to admin and
the password will be reset to atlantis, and the modem will be
accessible via its default IP address at http://192.168.1.254/
This is used when you can not login to the router, e.g. forgot
the password)
the password)
PWR
Connect the supplied power adapter to this jack.
POWER (Switch)
A Power ON/OFF switch.
2.4 Cabling
The most common problem is bad cabling or ADSL line. Make sure that all connected
devices are turned on. On the front of the product is a bank of LEDs. As a first check, verify
that the LAN Link, ADSL , PWR, SYS LEDs are lit. If they are not, verify that you are using
the proper cables.
Ensure that all other devices connected to the same telephone line as your router (e.g.
telephones, fax machines, analog modems) have a line filter (A01-AF2) connected between
devices are turned on. On the front of the product is a bank of LEDs. As a first check, verify
that the LAN Link, ADSL , PWR, SYS LEDs are lit. If they are not, verify that you are using
the proper cables.
Ensure that all other devices connected to the same telephone line as your router (e.g.
telephones, fax machines, analog modems) have a line filter (A01-AF2) connected between