Atlantis Land A02-RA242-W54_GX01 ユーザーズマニュアル

                                                  

             ENGLISH

 

35 

•  Virtual Circuit: Enable 
•  VPI: 0 or 1 (check with your ISP) 
•  VCI: 38 or 50 (check with your ISP) 
•  NAT: Enable 
•  Username:  Enter the username provided by your 

ISP(case sensitive). 

•  Password:  Enter the password provided by your ISP 

(case sensitive). 

•  Service Name: This item is for identification purposes. If 

it is required, your ISP will provide you the information. 

•  IP Adress:0.0.0.0 
•  Authentication Protocol Type: Default is Chap (Auto). 

Your ISP will advise you whether to use Chap or Pap. 

•  Connection:  Chose  Always On If you want the router 

to establish a PPPoE/A session when starting up and to 
automatically re-establish the PPPoE/A session when 
disconnected by the ISP. Chose Connect on Demand If 
you want to establish a PPPoE session only when there 
is a packet requesting access to the Internet. 

•  Idel Timeout: Auto-disconnect the Router when there is 

no activity on the line for a predetermined period of time. 

•  RIP: No Rip 
•  MTU: 1492 (PPPoE), 1500(PPPoA) 
Press Apply and then click on Save Config to Flash. 
Now You can check on  the section Status if connection is 
up and You can begin navigation.  For every other  problem 
refer to Manual or Multimedia Guide on attached cd-rom. 
 

 

You have to pay particular attention to the 
WAN-ADSL connection. If you have any 
doubt  turn to qualified personnel or contact  
Atlantis-Land technical assistance. Atlantis 
Land will not be considered  responsible in 
case of  wrong or bad configuration.